# Copyright 2008-2014 Cumulus Systems Incorporated.
# All Rights Reserved.

# This file will be initialized at install time.

#--------------------------------------------------------------------------------------------------
# CONFIGURATION SECTION
#--------------------------------------------------------------------------------------------------
# NOTE: TODO. Update it.
# The file /etc/cron.d/cronJobs contains a line that runs triggerDataCollection.pl every N minutes. 
# So long as (INTERVAL * SAMPLES) equals 120, no change in /etc/cron.d/cumulus will be needed.
# If INTERVAL * SAMPLES equals any other number, then look for 'MAIN DATA COLLECTION' in
# /etc/cron.d/cumulus and set N equal to: (INTERVAL * SAMPLES) / 60.

# Data collection interval in seconds. Default is one seconds.
INTERVAL=%INTERVAL%

# Number of samples collected into each data collection file.
# If collection interval is 1 second then number of samples will be 60.
# If collection interval is 1 minute then number of samples will be 15.
SAMPLES=%SAMPLES%

# XFER is data transfer interval in seconds. For non-real-time (batched) transfers, XFER should be
# greater than (INTERVAL * SAMPLES). For real-time transfers make XFER equal to 0.
XFER=%XFER%

# Maximum size of retry directory in MB.
SIZE_LIMIT_OF_BACKLOG_FILES=25

#--------------------------------------------------------------------------------------------------
# END CONFIGURATION SECTION
#--------------------------------------------------------------------------------------------------

#--------------------------------------------------------------------------------------------------
# User must not change the following configuration settings.
# To change these settings, you must contact Support team.
#--------------------------------------------------------------------------------------------------
# Linux export path.
export PATH=".:/usr/local/lib/cumulus:/usr/bin:/bin:$PATH";

# Probe appliance system.
DESTHOST=%DESTHOST%

# Used to send data to Probe appliance system.
DESTPORT=1111

# User on Probe appliance system.
DESTUSER=megha

# Execution frequency of "triggerDataCollection.pl".
# Change only if necessary. If it is changed then ensure that the changed value
# (Main CRON frequency * 60) / (Number of samples * Data collection Interval) is an integer value.
MAINCRONFREQ=15

# Number of iterations of execution in each collection cycle.
ITERATIONS=%ITERATIONS%

# Probe ID.
PROBEID=%PROBEID%

# Main log file.
MAINLOG=main.log
#--------------------------------------------------------------------------------------------------